I have a Standard Task Sequence with basically default steps, nothing real fancy. Just a few single Application installs, a cmd line to install a cert for a driver, and Apply Patches>Install Updates Offline in the end of Preinstall. The issue I'm having with it is after the client reboots, I can see it run through the steps recover from domain, tattoo, run command line (that's the cert install), and then it stops and says that it was unable to execute syspep. Later down the error messages is mentions capture. If this is a standard client task sequence, why on earth would it by trying to 'Sysprep and Capture'? I've tried searching for answers, but everthing I find pertaining to 'failed to execute sysprep' has to do with 'sysprep and capture' task sequences.
Normally I'm able to find some kind of answers on little things with MDT, but this one has me at a loss.