Ok so I was able to get my deployment share setup and ready for both Refresh and Replace Scenarios. The the replace scenario I store the old user data on a share. I created the master image on a VM and then captured it. I created a bootable media for usb.
I put it in the the new machines and it boots ti the windows deployment wizard. I go through the first steps and everything is ok. When I get to user data restore I am not able to specify the path. I opened the command prompt and I get an apipa address. I
went back and configured a static Ip and now it works. Windows finishes installing and DHCP is not working. If i configure it for static it will work but not for DHCP. I can use the same connection and connect it to my computer and it will work so its not
the port or connection. any ideas?
↧