Hi, I've run into a problem trying to boot into and MDT environment to perform an initial syprep and capture. after starting the VM I'm using it sits there for maybe a minute then goes to a command prompt, the only error i have been able to find is in wpeinit.log where the following two lines are logged
2019-05-02 20:02:56.384, Info Successfully executed command 'wscript.exe X:\Deploy\Scripts\LiteTouch.wsf' (exit code 0x00001577)
2019-05-02 20:02:56.384, Info STATUS: FAILURE (0x80071577)
then the final line
2019-05-02 20:02:56.384, Warning Applying WinPE unattend settings failed with status 0x80071577; ignoring shutdown settings
I can't find anything on any of these error codes.
I have tried updating the deployment share and have even gone as far as to create a new deployment server VM, install the ADK and MDT on that and try again with the same results. exploring the deployment VM shows that the scripts exists in the correct place and it can connect to the deployment server.
Any help would be greatly appreciated.